Raritan PX3-1000 series, User Manual

Page: 440 / 744

Chapter 8: Using the Command Line Interface
418
Interface Description
eth2 (PX3-iX7)
Determine the IPv6 configuration mode of the
ETH2 interface (wired networking).
wireless Determine the IPv6 configuration mode of the
WIRELESS interface (that is, wireless
networking).
bridge Determine the IPv6 configuration mode of the
BRIDGE interface (that is, bridging mode).

<mode> is one of the modes:
automatic or static.
Mode Description
automatic The IPv6 configuration mode is set to automatic.
static The IPv6 configuration mode is set to static IP
address.
Setting the IPv6 Preferred Host Name
After selecting DHCP as the IPv6 configuration mode, you can specify the
preferred host name, which is optional. The following is the command:
config:# network ipv6 interface <ETH> preferredHostName <name>
Variables:

<ETH> is one of the network interfaces: ethernet (or ETH1/ETH2),
wireless, bridge or all. Note that you must choose/configure the
bridge interface if your PX3 is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of the ETHERNET (or
ETH1/ETH2) and WIRELESS interfaces do NOT function.
Interface Description
ethernet (PX3) Determine the IPv6 preferred host name of the
ETHERNET interface (that is, wired networking).
eth1 (PX3-iX7) Determine the IPv6 preferred host name of the
ETH1 interface (wired networking).
eth2 (PX3-iX7) Determine the IPv6 preferred host name of the
ETH2 interface (wired networking).