Raritan PX3-1000 series, User Manual

Page: 390 / 744

Chapter 8: Using the Command Line Interface
368
With an Analog Modem
The PX3 supports remote access to the CLI via a connected analog
modem. This feature is especially useful when the LAN access is not
available.
To connect to the PX3 via the modem:
1. Make sure the PX3 has an analog modem connected. See
Connecting an Analog Modem
(on page 83).
2. Make sure the computer you are using has an appropriate modem
connected.
3. Launch a terminal emulation program, and configure its baud rate
settings according to the baud rate set for the analog modem
connected to the PX3. See
Configuring the Serial Port
(on page
325).
4. Type the following AT command to make a connection with the PX3.
ATD<modem phone number>
5. The CLI login prompt appears after the connection is established
successfully. Then type the user name and password to log in to the
CLI.
To disconnect from the PX3:
1. Return to the modem's command mode using the escape code +++.
2. After the OK prompt appears, type the following AT command to
disconnect from the PX3.
ATH