Chapter 7: Using SNMP
361
MIB download via the Device Information page:
1.
Choose Maintenance > Device Information.
2.
In the Information section, click the desired download link:
EMD2-MIB
ASSETMANAGEMENT-MIB
LHX MIB
3.
Click Save to save the file onto your computer.
Note: LHX-MIB is available only after the LHX/SHX support has been
enabled. See
Miscellaneous
(on page 332).
SNMP Gets and Sets
In addition to sending notifications, the PX3 is able to receive SNMP get
and set requests from third-party SNMP managers.
Get requests are used to retrieve information about the PX3, such as
the system location, and the current on a specific outlet.
Set requests are used to configure a subset of the information, such
as the SNMP system name.
Note: The SNMP system name is the PX3 device name. When you
change the SNMP system name, the device name shown in the web
interface is also changed.
The PX3 does NOT support configuring IPv6-related parameters
using the SNMP set requests.
Valid objects for these requests are limited to those found in the SNMP
MIB-II System Group and the custom PX3 MIB.
The PX3 MIB
The SNMP MIB file is required for using your PX3 device with an SNMP
manager. An SNMP MIB file describes the SNMP functions.
Summary of Contents for PX3-1000 series
