Raritan PX3-1000 series, User Manual, Page: 326 / 744

Chapter 6: Using the Web Interface
304

Cycle Outlet: Cycles power to the selected outlet(s).
4. To specify the outlet(s) where this action will be applied, select them
one by one from the Available Outlets list.

To add all outlets, click Select All.
5. To remove any outlets from the Selected Outlets field, click that
outlet's .

To remove all outlets, click Deselect All.
6. If "Turn Outlet On" or "Cycle Outlet" is selected in step 3, you can
choose to select the "Use sequence order and delays" checkbox so
that all selected outlets will follow the power-on sequence defined
on the page of
Outlets (on page 158).
Switch Peripheral Actuator
If you have any actuator connected to the PX3, you can set up the PX3 so
it automatically turns on or off the system controlled by the actuator
when a specific event occurs.
Note: For information on connecting actuators, see DX Sensor
Packages (on page 63).
Operation:
1. Choose Device Settings > Event Rules > .
2. Select "Switch peripheral actuator" from the Action list.
3. In the Operation field, select an operation for the selected
actuator(s).

Turn On: Turns on the selected actuator(s).

Turn Off: Turns off the selected actuator(s).
4. To select the actuator(s) where this action will be applied, select
them one by one from the Available Actuators list.

To add all actuators, click Select All.
5. To remove any selected actuator from the Selected Actuators field,
click that actuator's .

To remove all actuators, click Deselect All.