Raritan PX3-1000 series, User Manual, Page: 241 / 744

Chapter 6: Using the Web Interface
219
Note: If the device's cascading mode is set to 'Bridging' or its role is
set to 'Slave' in the port forwarding mode, the wireless settings will
be disabled.
5. To configure the ETHERNET (or ETH1/ETH2) interface settings, see
Ethernet Interface Settings
(on page 221).
6. Click Save.
After enabling either or both Internet protocols:
After enabling IPv4 and/or IPv6, all but not limited to the following
protocols will be compliant with the selected Internet protocol(s):

LDAP

NTP

SMTP

SSH

Telnet

FTP

SSL/TLS

SNMP

SysLog
Note: The PX3 supports TLS 1.0, 1.1 and 1.2.
Wired Network Settings
On the Network page, click the ETHERNET (or ETH1/ETH2) section to
configure IPv4/IPv6 settings.
If the device's cascading mode is set to 'Bridging', the BRIDGE section
appears. Then you must click the BRIDGE section for IPv4/IPv6 settings.
See
Setting the Cascading Mode
(on page 231).
Enable Interface:
Make sure the Ethernet interface is enabled, or all networking through
this interface fails. This setting is available in the ETHERNET (or
ETH1/ETH2) section, but not available in the BRIDGE section.
IPv4 settings:
Field/setting Description
Enable IPv4 Enable or disable the IPv4 protocol.