Chapter 5: Introduction to PDU Components
107
2.
Press
/
to turn on or off the actuator. A confirmation
message similar to the following is shown.
3.
Press
/
or
/
to select Yes or No, and then press
/
.
4.
Verify that the actuator status shown on the LCD display has been
changed.
Assets
If there are no Raritan asset management strips connected, the LCD
display shows the message "No asset strips connected" for the "Assets"
menu command.
After connecting asset strips, only the information of the rack units
where asset tags have been detected are shown on the LCD display.
To show asset strip information:
1.
Press
/
or
/
to select "Assets" in the Main Menu,
and press
/
.
2.
The display shows the available asset strip, and indicates how many
rack units and tags are detected on this strip.
Summary of Contents for PX3-1000 series
