Chapter 6: Using the Web Interface
311
Setting Up an LHX/SHX
Once a Schroff LHX/SHX heat exchanger is connected, you can set up
the device by giving it a name, and configure its setpoint air outlet and
default fan speed.
To set up the LHX/SHX:
1. Expand the Feature Port folder as needed.
2. Click the desired LHX/SHX device. Its page opens in the right pane.
3. Click Setup in the Settings section of the page. The Setup dialog
opens.
4. Type a name for the heat exchanger in the Name field. The
customized LHX/SHX heat exchanger's name is followed by the
device type in parentheses.
5. Enter the air outlet's temperature set point in the Setpoint Air Outlet
(°C) field.
6. Enter the default fan speed in the Default Fan Speed (%) field.
7. Click
OK.
Configuring Temperature and Fan Thresholds
An LHX/SHX heat exchanger is implemented with various sensors for
detecting the air temperature, water temperature, and fan speed.
You can set thresholds for these sensors so that the PX alerts you when
any sensor readings are getting close to a critical condition.
The LHX/SHX settings are stored on the FEATURE port where the
LHX/SHX device is connected, and are lost if that device is re-connected
to a different PX.
To configure the thresholds for a sensor:
1. Expand the Feature Port folder as needed.
2. Click the desired LHX/SHX device. Its page opens in the right pane.
Summary of Contents for PX2-1000 SERIES
