Raritan PX2-1000 SERIES, User Manual, Page: 135 / 648

Chapter 6: Using the Web Interface
116
Modifying Network Settings
The PX was configured for network connectivity during the installation
and configuration process. See
Configuring the PX
(on page 17). If
necessary, you can modify any network settings later.
Selecting the Internet Protocol
The PX device supports two types of Internet protocols -- IPv4 and IPv6.
You can enable either or both protocols. After enabling the desired
Internet protocol(s), all but not limited to the following protocols will be
compliant with the enabled Internet protocol(s):

LDAP

NTP

SMTP

SSH

Telnet

FTP

SSL/TLS

SNMP

SysLog
To select the appropriate Internet Protocol:
1. Choose Device Settings > Network. The Network Configuration
dialog appears.
2. Click the IP Protocol tab.
3. Select one checkbox according to the Internet protocol(s) you want
to enable:
 IPv4 only: Enables IPv4 only on all interfaces. This is the default.
 IPv6 only: Enables IPv6 only on all interfaces.
 IPv4 and IPv6: Enables both IPv4 and IPv6 on all interfaces.
4. If you selected the "IPv4 and IPv6" checkbox in the previous step,
you must determine which IP address is used when the DNS
resolver returns both IPv4 and IPv6 addresses.
 IPv4 Address: Use the IPv4 addresses returned by the DNS
server.
 IPv6 Address: Use the IPv6 addresses returned by the DNS
server.
5. Click OK.