Raritan PMC-1000, User Manual

Page: 525 / 621

Chapter 5: Using the Command Line Interface
513
Examples:
•
Example 1 (only one possible command):
a.
Type the first word and the first letter of the second word of the
"
reset factorydefaults
" command -- that is,
reset f
.
b. Then press Tab or Ctrl+i to complete the second word.
•
Example 2 (only one possible command):
a.
Type the first word and initial letters of the second word of the
"
security enforceHttpsForWebAccess
" command -- that
is,
security enf
.
b. Then press Tab or Ctrl+i to complete the second word.
• Example 3 (more than one possible commands):
a.
Type only the first two words of the "
network ipv4 gateway
xxx.xxx.xxx.xxx
" command -- that is,
network ipv4.
b. Then press Tab or Ctrl+i one or two times, a list of possible
commands displays as shown below.
gateway interface staticRoutes
c. Type the full command "
network ipv4 gateway
xxx.xxx.xxx.xxx
", according to the onscreen command list.
Logging out of CLI
After completing your tasks using the CLI, always log out of the CLI to
prevent others from accessing the CLI.
To log out of the CLI:
1. Ensure you have entered administrator mode and the # prompt is
displayed.
2. Type
exit
and press Enter.