OWL 640 N/USER MANUAL/03-20/REV1.0
9. XCAP CONTROL FEATURES
XCAP has many different control functions and analytical tools that can be used when
imaging the camera. For the full XCAP user guide, please refer to the link below:
http://epixinc.com/manuals/pixci_e14el/index.htm
This section will discuss in detail a few features on XCAP that Raptor thinks would be of
immediate use when using the camera.
9.1 Recording Images on XCAP
Capturing an image sequence is outlined in the full XCAP user manual (link in section 10).
Raptor also has a separate user manual which covers recording images on XCAP. Please
contact Raptor to obtain this manual.
9.2 Saving Preset Configuration Settings
Different camera and frame grabber settings can be saved in the
“Preset”
tab under the
“PIXCI *Frame Grabber Model*”
section of the GUI, as shown in Figure 16.
Up to three different presets can be saved per settings file. If the camera is set to a desired
state outside of the default parameters, clicking
“Save 1”
will save all the current parameter
states that have been set
.
This can be done a further two times. These camera states can
be recalled at any time by using the recall buttons. The overall settings file can then be
saved and loaded in this tab also. Three preset states are the maximum number that can be
saved in a settings file.
Figure 16: Preset Configuration Settings.
