Rapiscan Mobile Trace, User Manual

Page: 35 / 178

BHT Vapor Mode Calibration Tube
The internal butylated hydroxy toluene (BHT) calibrant tube inside the dopant chamber contains small white
crystals and is important for internal calibration when the device is in vapor mode. Typically, you should not need
to replace the internal calibrant tube unless it has been damaged, lost, or contaminated. It does not have to be
removed from the device prior to shipping. For further information about BHT consult the SDS, which is available
through Customer Service.
Figure 2-4 BHT vapor mode calibration tube
Powering Up the Device
1. Do one of the following:
• Plug the power supply cord into the rear panel by aligning the red dots on the two mating connectors
and pushing them together until fully engaged. Plug the power cord into the power supply, and the
other end into an AC electrical outlet supplying 90-264 VAC, 47-63 Hz.
• Plug the vehicle power adapter into the rear panel by aligning the red dots on the two mating
connectors and push them together until fully engaged. Plug the other end into a 12 VDC, which
provides the appropriate power with the vehicle running.
NOTE: To remove the power supply or vehicle power adapter you must grasp it close to the red dots and
pull toward you. There is a quick disconnect that releases it from the rear panel.
2. Push the power button on the rear panel.
NOTE: The green LED on the power button illuminates.
Logging On to the Device
The Log On screen displays each time the ITMS™ software is started or the computer is rebooted.
18
Rapiscan Systems Proprietary and Confidential
CHAPTER 2 │ User's Guide