49
Replacing the Button Board
1.
Follow steps 1 - 3 in the Stirrer Motor section to open the operation panel. See
“Replacing the Stirrer Motor” on page 42 for instructions.
2.
Disconnect the 12-pin button board cable from the button board and cut the plastic
cable tie tying the cable to operation panel.
√
√
NOTE:
The cable connector features a latch that requires the user to pinch in
order to disconnect it from the button board.
√
√
NOTE:
When replacing the button board, re-tie the button board cable to the
operation panel in the same location using a cable tie.
3.
Remove the four black M2.5x5 Phillips head self-tapping screws securing the button
board in place, and then remove it from the operation panel.
√
√
NOTE:
After the button board has been re-installed onto the top cover, press
each of the button on the operation panel to test them. If any of the
buttons cannot be pressed properly, slightly loosen the screw on the
button board closest to the respective button.
To install the button board, reverse the steps above.
Summary of Contents for FREDDA 1.0
Page 1: ...AI Rapid Cold Brew Maker Service Guide...
Page 2: ......
