DST30P Wheel Balancer
23
P/N 5900163 — Rev. C1 — March 2020
Operation
This section describes how to use your Balancer.
⚠
DANGER
Being in close proximity to a Balancer is a serious endeavor with potentially life-
threatening risks. Only trained, authorized, supervised personnel may be within 30
feet of the Balancer while it is in use.
Do not assume you are going to be
safe using the Balancer this time just because nothing happened
last time
.
Usage Precautions
Keep the following in mind while using the Balancer:
•
Make sure all Operators receive specific training in Wheel balancing
before
they are allowed to
use the Balancer, that their training is verified through a testing program, and that all training is
documented. All others, including children and untrained personnel,
must
be kept at least 30 feet
away from the Balancer while it is in use.
•
Make sure
new
Operators are trained and supervised in the use of the Balancer.
•
Do not use the Balancer while tired or under the influence of drugs, alcohol, or medication.
•
Make a visual inspection of the Balancer
before each use
. Do not operate the Balancer if you
find any issues. Instead, take the unit out of service, then contact your dealer, visit
, or call
(805) 933-9970
.
•
Keep the work area around the Balancer clean and well lit. Dirty, cluttered, and dark work areas
increase the chances of an accident happening.
•
Do not remove the Trays on the top of the Balancer unless instructed to do so by BendPak Ranger
Support. There are no user serviceable parts underneath.
•
You
must
wear OSHA-approved (Publication 3151) Personal Protective Equipment at all times
when installing, using, maintaining, or repairing the Balancer. Leather gloves, steel-toed work
boots, ANSI-approved eye protection, back belts, and hearing protection
are mandatory
.
⚠
WARNING
Always wear ANSI-approved eye protection. Although rare, an accident could
cause significant injuries to your eyes.
•
Do not use the unit in a wet environment or expose it to rain or excess moisture.
•
If an extension cord is necessary, a cord with a current rating equal to or more than that of the
Balancer must be used. Extension cords rated for less current than the equipment may overheat.
Care should be taken to arrange the extension cord so that it will
not
be tripped over or pulled.
•
Do not use the Balancer in the vicinity of open containers of flammable liquids.
•
Clean the Balancer according to the instructions in
•
Study the entire
Installation and Operation Manual
before using the Balancer.
Summary of Contents for DST30P
