Ranger DST-64T, Installation And Operation Manual

Page: 32 / 80

DST-64T / DST642D Wheel Balancers
32
P/N 5900192 — Rev. F — March 2021
Balancing Modes
Balancing Modes are based on the locations where the weight gets put on if the Wheel is out of
balance:
•
Dynamic (DYN) . The most common Balancing Mode; used with steel rims. If the Wheel is out of
balance, weight(s) are clamped on the Inner Edge and the Outer Edge.
• Static (STA) . Used for Wheels under 4 inches wide and motorcycle Wheels. If the Wheel is out of
balance, adhesive weight(s) are applied to the Center Plane only.
• Static 2 (STA2) . Also used for Wheels under 4 inches wide and motorcycle Wheels. If the Wheel
is out of balance, weight(s) are clamped to the Inner Edge only.
• Aluminum (ALU) . Used on Aluminum Alloy Wheels when you want adhesive weights to be
applied on the Inner Plane and the Center Plane.
• Hidden (HID) . Also used on Aluminum Alloy Wheels. HID Mode is very similar to ALU Mode; the
difference is that the weight that goes on the Center Plane can be split up and hidden behind
spokes in the Wheel.
Refer to Hidden Weight Balancing for specific instructions for using this Balancing Mode.