background image

- 2 - 

 

Chapter 1  Specifications 

 

 

GENERAL 

 

 

Model RCI-5054DX 

RCI-5054DX-100 

Frequency Range : 

50.000 ~ 54.000 MHz 

50.000 ~ 54.000 MHz 

Tuning Steps 

100 Hz, 1 KHz, 10 KHz,  

100 KHz, 1 MHz 

100 Hz, 1 KHz, 10 KHz,  

100 KHz, 1 MHz 

Emission 

USB, LSB, CW, AM, FM 

USB, LSB, CW, AM, FM 

Frequency Control 

Phase-Lock-Loop Synthesizer 

Phase-Lock-Loop Synthesizer 

Frequency Tolerance 

0.005% 

0.005% 

Frequency Stability 

0.001% 

0.001% 

Operating Temperature 

Range 

-10

O

C  to  +50

O

C -10

O

C  to  +50

O

Antenna Impedance  

50 ohm 

50 ohm 

Microphone 

Plug-In (6-Pin), 400 

 Dynamic PTT 

Plug-In (6-Pin), 400 

 Dynamic PTT 

Meter Function 

RF Output, RX Receive Signal 

Strength, SWR 

RF Output, RX Receive Signal 

Strength, SWR 

Input Voltage 

13.8 V DC 

13.8 V DC 

Dimensions 

7 3/4" (W) x 10 3/4" (D) x 2 3/8" (H) 

7 3/4" (W) x 9 3/4" (D) x 2 7/8" (H) 

Weight 

4 lb. 3 oz. 

5 lb. 13 oz. 

TRANSMITTER 

 

 

RF Power Output 

25W : USB/LSB Peak Power 

10W : CW/AM/FM 

100W : USB/LSB Peak Power 

50W : CW/AM/FM 

RF Transmit Modes 

USB, LSB, CW, AM, FM 

USB, LSB, CW, AM, FM 

Antenna Connector 

UHF Type, 50 

 

UHF Type, 50 

 

Modulation 

16F3, A3E, J3E, A1A 

16F3, A3E, J3E, A1A 

Spurious Emissions 

>60 dB 

>60 dB 

Carrier Suppression 

-50 dB 

-50 dB 

RECEIVER 

 

 

Sensitivity   

   AM/CW :  0.5 uV for 10dB  Sinad 

          FM :  0.25uV for 12dB Sinad 

 USB/LSB :  0.15uV for 10dB Sinad 

   AM/CW :  0.5 uV for 10dB  Sinad 

          FM :  0.25uV for 12dB Sinad 

 USB/LSB :  0.15uV for 10dB Sinad 

Image Rejection Ratio 

-65 dB 

-65 dB 

AGC Figure of Merit 

SSB/CW/AM : 80dB at 50mV for a 

10dB change in Audio Output 

SSB/CW/AM : 80dB at 50mV for a 

10dB change in Audio Output 

Audio Power Output 

2.5W 

2.5W 

( SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE )

 

- 3 - 

Chapter 2  Introduction

 

 

 

Congratulations on your purchase of an RCI-5054DX/5054DX-100 6 
meter amateur radio. Your RCI-5054DX/5054DX-100 is designed to 
provide trouble-free service and state-of-the-art communications in the 6 
meter band.  Please read this manual thoroughly to ensure proper 
performance. 

 

 

 

Unpacking

 

The following items are included with our RCI-5054DX/5054DX-100. 
Carefully remove and examine all materials from the packing carton. If 
any items are missing or appear damaged, please contact your dealer 
immediately. Each unit should include: 

 

(1) RCI-5054DX/5054DX-100 Transceiver 

 

(2) Dynamic Microphone with remote frequency adjustment switches 

 

(3) Power Cord 

 

(4) Mounting Bracket & Hardware 

 

(5) Installation Hardware 

 

(6) Owner's Manual 

 

(7) Warranty Registration Card 

 

It is recommended that you save the packing materials for future storage 
or shipping.

 

IMPORTANT 

To operate this radio, you must possess and amateur radio operator's 

license issued by the FCC. Operation of this unit without proper 

licensing is ILLEGAL and can result in severe penalties. 

NOTE 

The manufacturer is not responsible for any radio or TV interference 

caused by unauthorized modifications to this equipment. Such 

modifications could void the user’s authority to operate this equipment. 

Summary of Contents for RCI-5054DX-100












Reviews: