R&S ZVAX24, Quick Start Manual

Page: 22 / 30

Pulse Profile Measurement
R&S
®
ZVAX24
22 Quick Start Guide 1312.7985.62 ─ 03
Power calibrations and system error corrections for test setups with an extension unit can
be performed in the ordinary way.
3.3 Connecting the Extension Unit
The pulse profile measurement requires the following connections between the network
analyzer and the extension unit.
●
RF connection: Connect SOURCE IN (ZVAX) to SOURCE OUT (NWA) and
SOURCE OUT (ZVAX) to SOURCE IN (NWA). See also
chapter 2.1.3.1, "RF Con-
nectors Port 1" , on page 8.
●
Control connection: Connect USB FROM NWA (ZVAX) to any of the USB type A
connectors at the front or rear panel of the NWA. See also
chapter 2.2.2, "USB FROM
NWA" , on page 13.
●
Pulse generator connection: Connect CASCADE IN (ZVAX) to CASCADE (NWA)
using the using the RJ-45 cable supplied with the extension unit. See also
chap-
ter 2.2.6, "CASCADE IN" , on page 14.
The DUT is connected between the analyzer ports 1 and 2. The schematic test setup is
shown below.
Fig. 3-1: Test setup for pulse profile measurement
Connecting the Extension Unit