Basic Operation
R&S
®
ZNH
51
User Manual 1334.5985.02 ─ 02
Resetting the R&S
ZNH
A "Reset to Factory Settings" resets the R&S
ZNH to the factory defaults.
During a reset, the R&S
ZNH restores the original configuration. It also deletes all cus-
tomized datasets (limit lines, standards, channel tables, transducer tables etc.).
Instead, it will reinstall all the datasets that have been available after delivery.
Risk of data loss
All datasets you have saved are deleted during a factory reset.
Calibration data
After a factory reset, the R&S
ZNH is loaded with the default factory calibration data.
See
Chapter 8.1.1, "Calibration States"
1. In the "Instrument Setup" dialog box, select the "Reset to Factory Settings" item.
2. Confirm the entry with the rotary knob.
The R&S
ZNH initiates the reset procedure and shows a warning message box.
3. A corresponding dialog box opens for selection.
● Select "Yes" to perform the reset. During the reboot, it shows a corresponding
message.
● Select "No" to cancel the reset.
4.3
Connecting the R&S
ZNH to a PC
The R&S
ZNH comes with the R&S InstrumentView software package. This software
package features several tools that allow you to document measurement results, cre-
ate and edit the different datasets necessary for the instrument. For more information,
see the R&S InstrumentView software manual.
The .NET Framework 2.0 (or higher) is required to run the software properly.
You have to install the R&S InstrumentView software on the PC before you are able to
establish a connection.
Connecting the R&S
ZNH to a PC