R&S ZNH, User Manual, Page: 42 / 369

Basic Operation
R&S
®
ZNH
35 User Manual 1334.5985.02 ─ 02
For more information of trace label, see Chapter 8.2, "Performing Vector Network
Analysis Measurements" , on page 151 and Chapter 8.1.1, "Calibration States" ,
on page 148.
For information of the internal DC bias status, see "Configuring the BIAS output port"
on page 40.
For information of markers, display line and limit lines, see Chapter 8.4, "Analyzing
Measurement Results" , on page 163.
4.1.5 Parameter View
The parameter view contains the important hardware parameters used in the measure-
ment. It is operation mode dependent.
It is located at the right side and bottom section of the screen layout. See Figure 4-1 .
You can select any parameters in the "Parameter view" to adjust the configurations of
the hardware settings. See details of each parameter in
Chapter 8.3.1, "Configuring the
Horizontal Axis" , on page 157, Chapter 8.3.2, "Configuring the Vertical Axis" ,
on page 157 and Chapter 8.4.1, "Working with Traces" , on page 164.
Parameter Description
"Center", "Start", "Stop" Function-specific displays depending on the softkey
indicated in the softkey label. It is used to configure
one of the following:
●
Start, stop and center frequency for the mea-
surement.
See
Chapter 8.3.1, "Configuring the Horizontal
Axis" , on page 157.
"Span" Configure the frequency span of the measurement.
See Chapter 8.3.1, "Configuring the Horizontal
Axis" , on page 157.
Time, date Display time and date of the instrument. This is a
read-only field.
See Chapter 4.2.3, "Configuring Date and Time" ,
on page 42 and "Setting the date format"
on page 44.
"REF" Configure the reference level of the measurement.
See Chapter 8.3.2.1, "Changing the Reference
Value" , on page 157.
"RBW" Configure the resolution bandwidth used for the
measurement.
See Chapter 8.3.4, "Setting the Sweep Parameters" ,
on page 161.
Screen Layout and Elements