Remote Commands
R&S
®
ZNH
220
User Manual 1334.5985.02 ─ 02
Example:
SWE:COUN 64
Defines a sweep count of 64 sweeps.
INIT:CONT OFF
INIT;*WAI
Turns on single sweep mode, starts the sweep and waits for its
end.
[SENSe:]SWEep:POINts
<NrofPoints>
This command queries the number of measurement points in a single sweep.
This command is a query and therefore has no *RST value.
Parameters:
<NrofPoints>
Returns the number of sweep points.
Example:
SWE:POIN?
Returns the number of sweep points.
[SENSe:]SWEep:TIME
<SweepTime>
This command defines the sweep time.
If you set a sweep time with this command, the R&S
ZNH decouples the sweep time
from the span and the resolution and video bandwidths.
Parameters:
<SweepTime>
Range:
Specified in the datasheet.
*RST:
- (AUTO is set to ON)
Default unit: s
Example:
SWE:TIME 10s
Sets the sweep time to 10 s.
[SENSe:]SWEep:TIME:AUTO
<State>
This command couples and decouples the sweep time to the span and the resolution
and video bandwidths.
Parameters:
<State>
ON | OFF
*RST:
ON
Example:
SWE:TIME:AUTO ON
Switches on the coupling to frequency span and bandwidths.
TRIGger[:SEQuence]:HOLDoff[:TIME]
<TriggerDelay>
This command defines the length of the trigger delay.
Remote Control - Commands
