Instrument Tour
R&S
®
ZNH
22
Getting Started 1334.5979.02 ─ 03
Risk of instrument damage
To avoid damage to the tracking generator output, never apply currents
greater than 600 mA or voltages greater than 20 V to the BNC connectors if
the BNC connectors are not configured as BIAS output ports.
If they are configured as BIAS ports, never apply currents greater than 600
mA or voltages greater than 50 V.
Headphone jack
The 3.5 mm connector for headphones has an internal impedance of approxi-
mately 10 Ω.
USB type A connector
The USB port provides the USB interface to connect a memory stick and store
data sets or screenshots. It can also be used to control the operation of the exter-
nal power sensor.
Risk of electrical shock
To avoid electrical shock, the DC input voltage must never exceed the value
specified on the housing.
Risk of instrument damage
●
Make sure not to overload the RF input and keep within the maximum
allowed signal levels. Refer to the datasheet for the maximum allowed
signal levels.
●
To avoid damage to the coupling capacitor, input attenuator or the mixer,
the DC input voltage of 50 V must never be exceeded.
Top View
www.allice.de
Allice Messtechnik GmbH
