R&S ZNC3, User Manual, Page: 420 / 795

Command Reference
R&S
®
ZNC
404 User Manual 1173.9557.02 ─ 13
CALCulate<Chn>:MARKer<Mk>:DELTa[:STATe] <Boolean>
Switches the delta mode for marker
<Mk>
on trace no.
<Chn>
on or off. The marker must
be created before using
​
CALCulate<Chn>:
​
MARKer<Mk>[:
​
STATe]
​
ON
. If the active
trace contains no reference marker, the command also creates a reference marker.
Suffix:
<Chn>
.
Channel number used to identify the active trace.
<Mk> Marker number in the range 1 to 10.
Parameters:
<Boolean> ON | OFF - Enables or disables the delta mode.
*RST:
OFF
Example: Suppose that the active recall set contains an active trace no. 1.
CALC:MARK ON
Create marker no. 1 and set it to the center of the sweep range.
CALC:MARK:DELT ON
Create a reference marker at the center of the sweep range and
set marker 1 to delta mode.
Manual operation: See "Mkr Stimulus / On / Delta Mode" on page 193
CALCulate<Chn>:MARKer<Mk>:FORMat <OutFormat>
Defines the output format for the (complex) value of marker.
Note: The formats of the markers assigned to a trace are independent of each other and
of the trace format settings; see
​
CALCulate<Chn>:
​
FORMat
​
.
Suffix:
<Chn>
.
Channel number used to identify the active trace.
<Mk> Marker number in the range 1 to 10.
Parameters:
<OutFormat> MLINear | MLOGarithmic | PHASe | POLar | GDELay | REAL |
IMAGinary | SWR | LINPhase | LOGPhase | IMPedance |
ADMittance | DEFault | COMPlex | MDB | MLPHase | MDPHase
See list of parameters below.
*RST:
DEFault
Example: Suppose that the active recall set contains an active trace no. 1.
CALC:MARK ON; :CALC:MARK:FORM?
Create marker 1, assign it to the trace no. 1 and query its format.
The analyzer returns the format of the active trace.
Manual operation: See "Marker Format" on page 195
Assume that the marker result is given by the complex quantity z = x + jy. The meaning
of the parameters is as follows:
SCPI Command Reference