GUI Reference
R&S
®
ZNC
198
User Manual 1173.9557.02 ─ 13
Max / Min
Sets the active marker to the absolute maximum or minimum in the search range, i.e. to
the largest or smallest of all response values. If a complex trace format (e.g. a polar
diagram) is active, the marker is set to the measurement point with the maximum or
minimum magnitude.
"Max" and "Min"also overwrite the current "Search Mode" (--> "Search Min" and "Search
Max") and the "Peak Type" for the peak search functions.
Remote command:
MINimum | MAXimum
Center = Marker
Sets the center of the sweep range equal to the stimulus value of the active marker,
leaving the span unchanged. The active marker appears in the center of the diagram.
This function is useful to focus on the sweep segment of particular interest, e.g. after a
maximum or minimum search.
Remote command:
Next Peak / Peak Type
Sets the active marker to the next maximum or minimum in the search range, depending
on the "Peak Type" setting.
●
If "Max" is active, then the marker is set to the next maximum. The next maximum is
the maximum with the largest response value that is below the current marker
response value.
Trace Settings