R&S UPZ
Putting into Operation
Connection to the Test Setup
Operating Manual 1120.8610.14 - 05
21
For firmware version 4.0.1 or higher the path "C:\Program Files\Rohde-
Schwarz\UPX\3.18\RS.GPAudioAdditions\usb-to-serial" appears.
Continue with
The driver is being installed.
Quit the installation with
.
The Installation Wizard returns once again. Continue as described above.
Afterwards the following message
appears …
… which can be quit with
.
1.4.4.2 Installation on the R&S UPP/UPV with Windows 7 Operating System
When an R&S UPZ is connected to the R&S UPP/UPV the first time, the "Found New
Hardware Wizard" does not come automatically, as was the case with the Windows XP
operating system. Rather, driver installation must be selectively initiated.
Connect the R&S UPZ to the mains, switch it on and connect it via USB cable to one of
the USB ports on the R&S UPP/UPV.
Select "Start", then right-click "Computer" and left-click "Manage".
