R&S UPZ
Putting into Operation
Putting into Operation
Operating Manual 1120.8610.14 - 0
5
10
1.3 Putting into Operation
This section describes the basic steps to be taken when setting up the R&S UPZ for
the first time.
Shock hazard
Do not open the instrument casing. As a rule, normal operation of the instrument does
not require opening the casing. Observe the general safety instructions and regulations
at the beginning of the manual.
Risk of instrument damage
Before switching on the instrument, make sure that the following conditions are met:
●
Instrument casing is closed and all fasteners are tightened.
●
All fan openings are unobstructed and the airflow perforations are unimpeded. The
minimum distance from the wall is 10 cm.
●
The instrument is dry and shows no sign of condensation.
●
The instrument is operated in the horizontal position on an even surface.
●
The ambient temperature does not exceed the range specified in the data sheet.
●
Signal levels at the input connectors are all within the specified ranges.
●
Signal outputs are correctly connected and are not overloaded.
Note that the general safety instructions also contain information on operating
conditions that will prevent damage to the instrument. The instrument's data sheet may
contain additional operating conditions.
Failure to meet these conditions may cause damage to the instrument or other devices
in the test setup.
Risk of electrostatic discharge
Protect the work area against electrostatic discharge to avoid damage to electronic
components in the modules. For details, refer to the safety instructions at the beginning
of this manual.
