R&S SpycerNode 2U12, User Manual

Page: 55 / 136

Configuration
55
User Manual | 2902.3266.02 - 08
R&S Network Switch Configuration
SpycerNode
Configure MTU
Configure MTU (Jumbo Frames): The Value must be
9216
. These setting
have to be done for each port.
Using the network switch terminal perform the following steps.
Perform the following steps:
1. Enter
enable

The terminal changes to admin mode:
switch [master] #
2. Enter
configure terminal

The terminal changes to config mode:
switch [master] (config) #
3. Enter
interface [switch]/[port]-[switch]/[port]
shutdown
4. Enter
interface ethernet [switch]/[port]-[switch]/[port]
mtu 9216
(e.g.
1/1-1/16 mtu 9216
)
5. Enter
no interface [switch]/[port]-[switch]/[port] shutdown
6. Enter
configuration write
to save the configuration.
7. Enter
show interfaces
to check the configuration.
The network switch is finally configured.
Optional
Configure port for splitter cable
Configure the port for splitter cable to connect 10Gbit clients to the switch.
Perform the following steps:
•
Enter
interface ethernet 1/[port number you want to split]
module-type gsfp-split-4
Display IP interfaces
Perform the following steps:
•
Enter
show IP Interface
to connect via DHCP to display IP inter-
faces.