Remote-Control Commands
Satellite Navigation
204
User Manual 1178.6379.02 ─ 01
19 Remote-Control Commands
The following commands are required for signal generation with the satellite navigation
options in a remote environment. We assume that the R&S
SMW has already been set
up for remote operation in a network as described in the R&S
SMW documentation. A
knowledge about the remote control operation and the SCPI command syntax are
assumed.
Conventions used in SCPI command descriptions
For a description of the conventions used in the remote command descriptions, see
section "Remote Control Commands" in the R&S
SMW user manual.
The
SOURce:BB:GPS|GALileo|GLONass|BEIDou
subsystem contains commands
for configuring the GNSS standards.
Common suffixes
The following common suffixes are used in remote commands:
Suffix
Value range
Description
SOURce<hw>
[1]|4
available baseband signals
OUTPut<ch>
1 to 3
available markers
SVID<ch>
1 to 37 for GPS satel-
lites
1 to 50 for Galileo
satellite
193 to 195 for QZSS
satellites
distinguishes between the SV IDs
ECHO<s2us0>
1 to 9
echoes in the multipath configuration
V<st>
V<us>
1
number of simulated vechicles
A<ch>
A<gr>
1 to 2
number of simulated antennas
STReam<st>
1 to 2
number of GNSS streams
Required options
