R&S SMJ100A, Operating Manual, Page: 719 / 874

Remote Control Commands
R&S
®
SMJ100A
703 Operating Manual 1403.7458.32 ─ 14
<PhaseN> float
Range:
-360 to 360
Increment: 0.1
Example: CORR:CSET:DATA:POW:SGAM:PHAS
-360.0,-180.0,180.0,360.0
sets the phase values.
[:SOURce<hw>]:CORRection:CSET:DATA:SGAMma:PHASe:POINts?
Queries the number of phase entries in the selected multi level user correction table.
Return values:
<Points> integer
Example:
CORR:CSET 'D:\user\multilevelucor1'
selects the data table
multilevelucor1
.
CORR:CSET:DATA:SGAM:PHAS:POIN?
queries the number of phase entries.
Response:
40
the table contains 40 phase values.
Usage: Query only
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe
The command fills the selected user correction list with the level values measured by
the power sensor for the given frequencies.
To select the used power sensor set the suffix in key word
SENSe
.
Example: CORR:CSET:DATA:SENS:POW:SONC
fills the user correction list with level values acquired by the
power sensor connector to the SENSOR connector.
Usage: Event
Manual operation: See "Fill User Correction Data with Sensor" on page 230
[:SOURce]:CORRection:CSET:DELete <Filename>
Deletes the specified table.
The lists are stored with the fixed file extensions
*.uco
in a directory of the user's
choice. The directory applicable to the commands is defined with the command
MMEMory:CDIR
. A path can also be specified in command
SOUR:CORR:CSET:CAT?
,
in which case the file in the specified directory is deleted.
Setting parameters:
<Filename> <table name>
SOURce Subsystem