R&S SMJ100A, Operating Manual

Page: 612 / 874

Remote Control Commands
R&S
®
SMJ100A
596 Operating Manual 1403.7458.32 ─ 14
Parameters:
<Frequency> float
Range:
100 to depends on hardware
Increment: 0.01
*RST:
1000
Default unit: Hz
Example: BB:ARB:TSIG:SINE:FREQ 100 kHz
sets a sine signal of 100 kHz.
Manual operation: See "Frequency (Sine Test Signal)" on page 391
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:PHASe <Phase>
The command sets the phase offset of the sine wave on the Q channel relative to the
sine wave on the I channel.
Parameters:
<Phase> float
Range:
-180 to 180
Increment: 0.01
*RST:
90
Default unit: DEG
Example: BB:ARB:TSIG:SINE:PHAS 90
sets a phase offset of 90 degrees.
Manual operation: See "Phase Offset Q (Sine Test Signal)" on page 391
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:SAMPles <Samples>
The command sets the sample rate for the sine signal in samples per period.
The resulting clock rate must not exceed the maximum ARB clock rate of 100 MHz.
The maximum value is automatically restricted by reference to the set frequency and
has to fulfill the rule Frequency * Samples <= ARB clock rate.
Parameters:
<Samples> integer
Range:
4 to 1000
*RST: 100
Default unit: 100 samples per period
Example: BB:ARB:TSIG:SINE:SAMP 100
sets a sample rate of 100 samples per period.
Manual operation: See "Samples per Period (Sine Test Signal)" on page 391
SOURce:BB:ARB:MCAR Subsystem
The
MCARrrier
subsystem contains the commands for setting the Multi Carrier Wave-
form Generator.
SOURce Subsystem