R&S SMJ100A, Operating Manual

Page: 604 / 874

Remote Control Commands
R&S
®
SMJ100A
588 Operating Manual 1403.7458.32 ─ 14
Example: BB:ARB:SEQ SING
sets trigger mode Single.
BB:ARB:TRIG:SLUN SEQ
sets unit Sequence length for the entry of sequence length.
BB:ARB:TRIG:SLEN 2
sets a sequence length of 2 waveforms. The current waveforms
will be output twice after the next trigger event.
Manual operation: See "Signal Duration Unit" on page 379
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SMODe <SMode>
The command selects the extended trigger mode for multi segment waveforms.
Parameters:
<SMode> SAME | NEXT | NSEam | SEQuencer
NSEam = Next Segment Seamless
*RST:
NEXT
Example: SOUR:BB:ARB:SEQ AUTO
selects trigger mode AUTO.
SOUR:BB:ARB:TRIG:SMOD SAME
the same segment of the waveform is output repeatedly.
Manual operation: See "Next Segment Mode" on page 383
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SOURce <Source>
Selects the trigger source.
Parameters:
<Source> INTernal|BEXTernal|EXTernal
INTernal
manual trigger or
*TRG
.
EXTernal|BEXTernal
trigger signal on the TRIGGER 1/2 connector.
*RST:
INTernal
Example: SOURce1:BB:ARBitrary:TRIGger:SOURce EXTernal
sets external triggering via the TRIGGER 1 connector.
Manual operation: See "Trigger Source" on page 380
[:SOURce<hw>]:BB:ARBitrary:TRIGger:DELay:UNIT <TrigDelUnit>
Determines the units the trigger delay is expressed in.
Parameters:
<TrigDelUnit> SAMPle | TIME
*RST:
SAMPle
Manual operation: See "External Delay Unit" on page 381
SOURce Subsystem