R&S SMJ100A, Operating Manual

Page: 600 / 874

Remote Control Commands
R&S
®
SMJ100A
584 Operating Manual 1403.7458.32 ─ 14
Example: BB:ARB:TRIG:SOUR INT
sets internal triggering.
BB:ARB:TRIG:SEQ ARET
sets Armed_Retrigger mode, i.e. every trigger event causes
waveform output to restart.
BB:ARB:TRIG:EXEC
executes a trigger, waveform output is started.
BB:ARB:TRIG:ARM:EXEC
waveform output is stopped.
BB:ARB:TRIG:EXEC
executes a trigger, waveform output is started again.
Usage: Event
Manual operation: See "Arm" on page 380
[:SOURce<hw>]:BB:ARBitrary:TRIGger:EXECute
The command executes a trigger. The internal trigger source must be selected using
the command
ARB:TRIGger:SOURce INTernal
and a trigger mode other than
AUTO
must be selected using the command
:ARB:SEQuence
.
Example: BB:ARB:TRIG:SOUR INT
sets internal triggering.
BB:ARB:SEQ RETR
sets Retrigger mode, i.e. every trigger event causes signal out-
put to restart.
BB:ARB:TRIG:EXEC
executes a trigger.
Usage: Event
Manual operation: See "Execute Trigger" on page 376
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal]:SYNChronize:OUTPut
<Output>
(enabled for "Trigger Source" External)
Enables/disables output of the signal synchronous to the external trigger event.
SOURce Subsystem