R&S SMJ100A, Operating Manual

Page: 57 / 874

Preparing for Use
R&S
®
SMJ100A
41 Operating Manual 1403.7458.32 ─ 14
Select "Start > Control Panel > Devices and Printers > Device Manager > Update
Device drivers" to install the driver.
2.4.2 Connecting a Monitor
An external monitor with an analog interface can be connected to the MONITOR con-
nector on the rear panel of the instrument. Per default, the external monitor connector
is disabled and has to be enabled before operation.
Connecting external devices
Before connecting any external device such as a monitor, make sure that the instru-
ment is switched off (or in standby mode). Otherwise, correct operation cannot be
assured. This does not apply to USB devices.
1. Shut down the instrument .
None of the front-panel LEDs should be on.
2. Plug in the monitor cable to the MONITOR connector on the rear panel of the
instrument.
3. Start up the instrument .
The green LED must be on.
The external monitor is detected.
The entire display of the instrument, containing the status bar, the block diagram
and the winbar is displayed on the monitor additionally. Further settings are not
required.
The MONITOR interface is described in "Appendix A: Hardware Interfaces" in the
Operating Manual.
2.5 Windows Operating System
The instrument contains the Windows Embedded Standard operating system which
has been configured according to the instrument's features and needs. Changes in the
system setup are only required when peripherals like keyboard or a printer are installed
or if the network configuration does not comply with the default settings. After the
R&S
SMJ is started, the operating system boots and the instrument firmware is started
automatically.
To ensure that the instrument software functions properly, certain rules must be
adhered to concerning the operating system.
Windows Operating System