R&S SMJ100A, Operating Manual

Page: 271 / 874

Instrument Function
R&S
®
SMJ100A
255 Operating Manual 1403.7458.32 ─ 14
5.5.13 LF Frequency Sweep
The "LF Frequency Sweep" dialog is used to configure and activate an LF frequency
sweep signal.
To open the "LF Frequency Sweep" dialog, select "RF/A Mod > Configure > LF Fre-
quency Sweep" or use the MENU key under "RF/A Mod".
The top sections of the combined dialog "LF Frequency Sweep / LF Output" provide
access to the "LF Frequency Sweep" mode settings.
The LF sweep mode is activated and the sweep mode is selected. The buttons are
used to reset the LF sweep (all sweep modes) or to execute the LF sweep ("Single"
mode).
The sweep range, sweep spacing and dwell time are set in the bottom of the section.
The lower section provides access to the "LF Output" settings, see Chapter 5.5.12.2,
"LF Output" , on page 254.
State
Activates the LF frequency sweep signal generation.
Note:
Activating a sweep mode automatically deactivates other sweeps and the list mode.
Remote command:
[:SOURce<hw>]:LFOutput:FREQuency:MODE
on page 739
Mode
Selects the LF frequency sweep mode.
RF Signal and Analog Modulations - RF Block