R&S SMJ100A, Operating Manual

Page: 159 / 874

Instrument Function
R&S
®
SMJ100A
143 Operating Manual 1403.7458.32 ─ 14
Baseband Trigger Input Slope
Selects the polarity of the active slope of an externally applied trigger signal.
This setting affects the TRIGGER inputs (BNC connectors).
Remote command:
[:SOURce]:INPut:TRIGger:BBANd:SLOPe
on page 722
Instrument Trigger Input Slope
Sets the polarity of the active slope of an externally applied instrument trigger.
This setting affects the TRIGGER 1/2 input (BNC connector at the rear of the instru-
ment).
"Positive" activates the rising edge of the trigger signal.
"Negative" activates the falling edge of the trigger signal.
Remote command:
[:SOURce]:INPut:TRIGger:SLOPe
on page 723
Clock Input Slope
Sets the polarity of the active slope of an externally applied bit clock pulse or symbol
clock pulse.
This setting affects the CLOCK input (BNC connector).
Remote command:
:CLOCk:INPut:SLOPe
on page 525
Clock Output Mode
Sets the output of bit or symbol clock pulses at the CLOCK OUT connector at the rear
panel.
Remote command:
:CLOCk:OUTPut:MODE
on page 525
5.2.3.11 Display/Keyboard Settings
In the "Display/Keyboard Settings" dialog the power-save mode and external keyboard
settings are made. It is opened using the SETUP or MENU key under "Environment".
Screen Saver Active
Activates/deactivates the screen-save mode of the display.
General Instrument Settings