R&S SMCVB-K163, User Manual

Page: 65 / 92

Remote-Control Commands
R&S
®
SMCVB-K163
65 User Manual 1179.0997.02 ─ 02
PBEC
PRBS before convolutional encoder
Pure pseudo-random bit sequence (PRBS) data used as modu-
lation data with no packet structure. The sequence is inserted
before the convolutional encoder. PRBS data conforms with
ITU-
T O.151 specification.
PAFC
PRBS after convolutional encoder
Pure pseudo-random bit sequence (PRBS) data used as modu-
lation data with no packet structure. The sequence is inserted
after the convolutional encoder.
*RST:
TTSP
Example: See Example "Configure test signal properties" on page 63.
Manual operation: See " Test Signal " on page 19
[:SOURce<hw>]:BB:DVBT:TSPacket <TSPacket>
Specifies the structure of the test transport stream packet that is fed to the modulator.
Parameters:
<TSPacket> S187 | H184
*RST:
H184
Example: See Example "Configure test signal properties" on page 63.
Manual operation: See "Test TS Packet" on page 22
6.2.4 IP Subsystem
The
SOURce:BB:INPut:IP
subsystem contains the commands for configuring input
IP data from a local IP data network.
To configure local IP data network parameters, see Chapter 6.7, "BCIP Subsystem" ,
on page 82.
Common suffixes
The following common suffixes are used in the
SOURce:BB:INPut:IP
remote com-
mands:
Suffix Value range Description
IP<ch> 1 to 4 IP channel number
Input Commands