R&S SMCVB-K156, User Manual

Page: 42 / 79

T-DMB/DAB Configuration and Settings
R&S
®
SMCVB-K156
42 User Manual 1179.1029.02 ─ 02
Remote command:
:SYSTem:COMMunicate:BCIP<hw>:NETWork:IPADdress:MODE
on page 71
IP Address
Displays the IP address of the instrument in the local IP data network.
By default, the R&S SMCV100B is configured to use dynamic TCP/IP configuration
and to obtain the whole address information automatically.
If the network does not support DHCP or the attempt does not succeed, the instrument
tries to obtain the IP address via Zeroconf (APIPA) protocol. IP addresses assigned via
Zeroconf start with the number blocks
169.254.*.*
.
Note: An IP address that is assigned via the Zeroconf protocol although the network
requires an IP address assigned via the DHCP server can cause network connection
failures.
Remote command:
:SYSTem:COMMunicate:BCIP<hw>:NETWork:IPADdress
on page 71
Protocol
Sets the protocol type of the input IP data.
The current firmware supports UDP and UDP/ RTP .
Remote command:
:SYSTem:COMMunicate:BCIP<hw>:NETWork:PROTocol
on page 72
Subnet Mask
Displays the bit group of the subnet in the host identifier.
To assign the subnet mask manually, select "Address Mode > Static".
Remote command:
:SYSTem:COMMunicate:BCIP<hw>:NETWork:IPADdress:SUBNet:MASK
on page 71
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
MAC Address
Displays the MAC address, a unique identifier of the network adapter in the
R&S
SMCV100B.
Remote command:
:SYSTem:COMMunicate:BCIP<hw>:NETWork:MACaddress
on page 71
Local IP Data Network Settings