Preparing for use
R&S
®
SMCV100B
27
Getting Started 1432.7046.02 ─ 04
c) Insert and push the adapter into the cage of the SFP+ socket of the IP
Data connector.
d) To mount the adapter, push the release bracket down to close the bracket.
The adapter is connected to the IP Data connector.
3. Plug the RJ-45 cable into the RJ-45 socket of the adapter.
To disconnect from IP Data interface
1. Unplug the RJ-45 cable.
2. Open the release bracket.
3. Carefully pull the SFP+ to RJ-45 adapter out of the SFP+ socket of the IP
Data interface.
Use the IP Data interface as input of external coding IP data for broadcast base-
band signals.
See also chapter "Local IP Data Network Settings" in the corresponding broad-
cast standard user manuals.
4.14
Switching on or off
The following table provides an overview of power states, LEDs and power switch
positions.
Table 4-1: Overview of power states
State
LED
Position of power switch
Off
gray
[0]
Standby
orange
[I]
Ready
green
[I]
To switch on the R&S
SMCV100B
The R&S
SMCV100B is off but connected to power. See
1. Set the switch on the power supply to position [I].
.
The LED of the [On/Standby] key is orange.
Switching on or off
