R&S SGT100A, User Manual

Page: 498 / 593

Remote Control Commands
R&S
®
SGT100A
467 User Manual 1176.8674.02 ─ 07
[:SOURce]:POWer:ATTenuation:RFOFf:MODE <Mode>
Determines the attenuator's state after the instrument is switched on.
Parameters:
<Mode> MAX | FATTenuated | FIXed | UNCHanged
Manual operation: See "RF-Off-Mode" on page 210
[:SOURce]:POWer:ATTenuation:SOVer[:OFFSet] <Offset>
Sets the switch-over offset value of the attenuator.
Parameters:
<Offset> float
Range:
-10 to 10
Increment: 0.1
*RST:
0
Manual operation: See "SATT Switch-Over Offset" on page 209
[:SOURce]:POWer:LIMit[:AMPLitude] <Amplitude>
Sets the upper limit of the RF signal power.
The value is not affected by an instrument preset and
*RST
function. This parameter is
influenced only by the factory preset (
SYST:FPR
) and its factory value is equal to the
upper limit.
Parameters:
<Amplitude> float
Range:
-120 to 25
Increment: 0.01
Manual operation: See "Limit" on page 208
[:SOURce]:POWer:LMODe <LevMode>
Selects the level mode.
Parameters:
<LevMode> NORMal | LOWNoise | LOWDistortion | USER
NORM
automatic selection of the best settings
LNOISe
settings for lowest noise
LDIStortion
settings for lowest distortions
Manual operation: See "Mode" on page 207
SOURce Subsystem