Signal Generator Settings
R&S
®
SGT100A
226
User Manual 1176.8674.02 ─ 07
Remote command:
Sensor
Indicates the connector to that the sensor is connected.
State
Activates level measurement.
Remote command:
:INITiate<ch>[:POWer]:CONTinuous
To query the availability of a sensor at a given connector, use the command
SENSe<ch>[:POWer]:STATus[:DEVice]?
Display
Sets the display mode for power readings.
Permanent ← Display
Activates the permanent indication of the power measurement result in the block dia-
gram. The instrument shows the type of sensor, the used connector, the measurement
source and, if set, the offset.
You can activate the permanent display for several sensors.
Remote command:
:SENSe<ch>[:POWer]:DISPlay:PERManent:STATe
Priority ← Display
Sets the display of results on mean or peak power.
Remote command:
:SENSe<ch>[:POWer]:DISPlay:PERManent:PRIority
Zero
Activates the auto zero function.
For details, see
Remote command:
Source
Selects the source for measurement.
"RF"
Assigns the signal to the RF path of the R&S
SGT.
The sensor measures the power of the RF signal at the current fre-
quency. It considers the correction factor and uses the level setting of
the instrument as reference level. Frequency variations are automati-
cally routed to the sensor.
"User"
Selects any freely selectable signal source, for example for measure-
ment of amplifier gain with 2 sensors.
Set the parameter
to the measurement's frequency.
RF Settings