Signal Generator Settings
R&S
®
SGT100A
101
User Manual 1176.8674.02 ─ 07
This multi carrier waveform is saved with the filename specified in "Output File". If no
filename is specified, the "File Manager" opens so that the filename can be entered. As
with normal waveforms, the file extension is
*.wv
.
Depending on the configuration of the multi carrier waveform, calculation may take
some time. A panel with a progress bar and an "Abort" button appears during the cal-
culation process.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CREate
Create and Load
Creates a new multi carrier waveform defined by the multi carrier table and general
setting entries and loads it subsequently in the "ARB" main menu.
This multi carrier waveform is saved with the filename specified in "Output File". If no
filename is specified, the "File Manager" opens so that the filename can be entered. As
with normal waveforms, the file extension is
*.wv
.
Depending on the configuration of the multi carrier waveform, calculation may take
some time. A panel with a progress bar and an "Abort" button appears during the cal-
culation process.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CLOad
Multi Carrier Table
The "Multi Carrier Table" dialog is opened by means of the "Carrier Table" button in the
middle part of the Multi Carrier Waveforms menu. The carrier settings can be checked
in the graphical "Carrier Graph" subdialog.
The "Carrier Table Assistant" section can be used to set a selectable carrier range.
This section serves as a optional mean to quickly set up a multi carrier scenario within
a specified carrier range.
Baseband
