Protocol analysis
R&S
®
RTO6
718
User Manual 1801.6687.02 ─ 05
13.14.2.3
Display settings
Access: [Bus] > "Display" tab.
For common display settings, see
Decode Layer
Selects the decode layer.
Decoding is performed in several steps, and the end results are presented in the
decode table. The decode layer selects an interim step for which the decoding result is
shown in the honeycomb display.
Available are:
●
"Off"
●
"Edges"
●
"Binary"
13.14.2.4
Configuring the SpaceWire signals
For configuration, assign the lines to the input channels and define the logical thresh-
olds and the hysteresis.
1. Press the [Bus] key on the front panel.
2. Select the tab of the bus you want to set up, for example "SB1".
3. In the "Setup" tab, set "Protocol"="SpaceWire".
4. Select the source and polarity for the strobe and data signals.
5. Enter the "Threshold" and the "Hysteresis" for the strobe and data signals.
6. Set the "Sync Settings" and the "Bit Position" if necessary.
7. Enable "Decode".
SpaceWire (option R&S
RTO6-K530)
