Getting started
R&S
®
RTO6
32
User Manual 1801.6687.02 ─ 05
Figure 3-2: Rear panel of R&S
RTO6
1 = USB device connector, type B
2 = USB connectors, type A
3 = LAN connector
4 = HDMI connector for external monitor
5 = AC power supply connector and main power switch
6 = DisplayPort connector
7 = Option slot for R&S
RTO6-B6 (waveform generator, shown in figure) or R&S
RTO6-B7 (pulse source)
8 = Option slot for R&S
RTO6-B1 (MSO, shown in figure) or R&S
RTO6-B1E (for R&S
RT-ZVC), or
R&S
RTO6-B10 (GPIB)
9 = Kensington lock slot to secure the instrument against theft
10 = Ref In, Ref Out: reference input, and output of the OCXO reference signal
11 = External trigger input
12 = External trigger output
13 = Slot for optional exchangeable solid state disk (option R&S
RTO6-B19)
AC power supply connector and main power switch
Connection to the AC power line. The R&S
RTO6 can be used with different AC power
voltages and adapts itself automatically to it. The nominal voltage and frequency
ranges are displayed on the rear panel and quoted in the data sheet.
If grounding is
not
ensured by the mains system, ground the oscilloscope using the
protective earth conductor on the front panel and an appropriate cable.
Instrument tour
