Remote control commands
R&S
®
RTO6
2554
User Manual 1801.6687.02 ─ 05
Query parameters:
<VoltageMeasType> VOLTage | CURRent
*RST:
VOLTage
Return values:
<Result>
Statistic result
Usage:
Query only
POWer:RIPPle:RESult:STDDev[:ACTual]?
[<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:AVG?
[<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:EVTCount?
[<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:NPEak?
[<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:PPEak?
[<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:RMS?
[<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:STDDev?
[<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:WFMCount?
[<VoltageMeasType>]
Return the specified statistic result for the standard deviation of the long-term mea-
surement results.
●
[:ACTual]: current measurement result
●
AVG: average of the long-term measurement results
●
EVTCount: number of measurement results in the long-term measurement
●
NPEak: negative peak value of the long-term measurement results
●
PPEak: positive peak value of the long-term measurement results
●
RMS: RMS value of the long-term measurement results
●
STDDev: standard deviation of the long-term measurement results
Query parameters:
<VoltageMeasType> VOLTage | CURRent
*RST:
VOLTage
Return values:
<Result>
Statistic result
Usage:
Query only
24.23.15
Transient response
This measurement is a single shot measurement. To start the measurement, use the
RUNS
command.
Progragramming example:
Chapter 24.3.8.2, "Transient response measurement"
.......................................................................................2555
.........................................................................................2555
.....................................................................................2555
..................................................................................... 2555
.............................................................................................. 2555
Power analysis (option R&S
RTO6-K31)
