Remote control commands
R&S
®
RTO6
2057
User Manual 1801.6687.02 ─ 05
Note that the high and low thresholds and the hysteresis values are dependent, so it is
sufficient to define two values for each line.
Suffix:
<m>
.
1..4
Parameters:
<ThresDatPos>
Range:
0 to 2.5
Increment: 0.1
*RST:
0.72
Default unit: V
BUS<m>:RFFE:DATA:THReshold:LOW
<ThresDatNeg>
Set the negative going threshold (V
TN
) for the data signal.
Note that the high and low thresholds and the hysteresis values are dependent, so it is
sufficient to define two values for each line.
Suffix:
<m>
.
1..4
Parameters:
<ThresDatNeg>
Range:
0 to 2.5
Increment: 0.1
*RST:
0.48
Default unit: V
BUS<m>:RFFE:DATA:THReshold:HYSTeresis
<ThresDatHyst>
Set the hysteresises between V
TP
and V
TN
for the data signal.
Note that the high and low thresholds and the hysteresis values are dependent, so it is
sufficient to define two values for each line.
Suffix:
<m>
.
1..4
Parameters:
<ThresDatHyst>
Range:
0 to 1
Increment: 0.1
*RST:
0.2
Default unit: V
BUS<m>:RFFE:CLOCk:THReshold:HIGH
<ThresClkPos>
Set the positive going threshold (V
TP
) for the clock signal.
Note that the high and low thresholds and the hysteresis values are dependent, so it is
sufficient to define two values for each line.
Suffix:
<m>
.
1..4
Protocols
