Remote control commands
R&S
®
RTO6
1869
User Manual 1801.6687.02 ─ 05
BUS<m>:FLXRay:POLarity
<Polarity>
Selects the wire on which the bus signal is measured in case of SINGle source type.
The setting affects the digitization of the signal.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Polarity>
BPLus | BMINus
*RST:
BPLus
BUS<m>:FLXRay:BITRate
<Bitrate>
Selects the number of transmitted bits per second.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Bitrate>
M10 | M5 | M2_5
10, 5, or 2.5 Mbit/s.
The return value of 2.5 Mbit/s is M25.
*RST:
M10
Example:
BUS:FLXRay:BITRate M2_5
BUS:FLXRay:BITRate?
M25
BUS<m>:FLXRay:CHTYpe
<Channel>
Selects the channel on which the signal is measured. The setting is considered in the
calculation of the frame CRC.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Channel>
CHA | CHB
Channel A or channel B
*RST:
CHA
BUS<m>:FLXRay:SEHB
<SeparateHdrBts>
The command affects the decoding and its display. If ON, the leading five indicator bits
of the header are decoded as five single bits. Otherwise, the indicator bits are shown
as one word with word length five bit.
Protocols
