Remote control commands
R&S
®
RTO6
1745
User Manual 1801.6687.02 ─ 05
Suffix:
<n>
.
1..4
1 if trigger type is DATA or WINDow
Specifies the condition number if trigger type is CONDition:
–
1 | 2 for I²S standard, left- und right-justified data formats
–
1 | 2 | 3 | 4 for TDM signals
Parameters:
<Channel>
ANY | TDMC1 | TDMCh1 | TDMC2 | TDMCh2 | TDMC3 |
TDMCh3 | TDMC4 | TDMCh4 | TDMC5 | TDMCh5 | TDMC6 |
TDMCh6 | TDMC7 | TDMCh7 | TDMC8 | TDMCh8 | LEFT |
RIGHT | RIGHt
ANY
The instrument triggers on any channel on which the specified
data is found.
LEFT | RIGHT = RIGHt
Available for I²S Standard, left- und right-justified data formats.
TDMCh1 | TDMCh2 | TDMCh3 | TDMCh4 | TDMCh5 | TDMCh6
| TDMCh7 | TDMCh8
Available for TDM audio signals
TDMC1 = TDMCh1, TDMC2 = TDMCh2, TDMC3 = TDMCh3,
TDMC4 = TDMCh4, TDMC5 = TDMCh5, TDMC6 = TDMCh6,
TDMC7 = TDMCh7, TDMC8 = TDMCh8. Query returns short
form.
Note
: Available audio channels depend on the configuration of
specifies the number of channels in a TDM frame.
*RST:
ANY
TRIGger<m>:I2S:TCONdition<n>:CONDtion
<DataCondition>
Sets the operator to set a specific data pattern or a data pattern range.
Suffix:
<n>
.
1..4
1 if trigger type is DATA or WINDow
Specifies the condition number if trigger type is CONDition:
–
1 | 2 for I²S standard, left- und right-justified data formats
–
1 | 2 | 3 | 4 for TDM signals
Parameters:
<DataCondition>
OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
OFF = ANY
No range is defined.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with
TRIGger<m>:I2S:TCONdition<n>:DMIN
Protocols
