Remote control commands
R&S
®
RTO6
1333
User Manual 1801.6687.02 ─ 05
ACQuire:MUWaveform
<MultiWaveform>
For each channel, up to three waveforms can be shown and analyzed. The decimation
mode and the waveform arithmetic are specific for each waveform. So you can analyze
several aspects of the signal: For example, waveform1 shows the peaks, and wave-
form2 shows the average of the signal.
Parameters:
<MultiWaveform>
ON | OFF
*RST:
OFF
Usage:
Asynchronous command
Firmware/software:
FW 3.20
CHANnel<m>[:WAVeform<n>][:STATe]
<State>
Activates or deactivates a waveform.
[:STATe]
can be omitted.
Suffix:
<m>
.
1..4
Selects the input channel.
<n>
1..3
Selects the waveform. If [:WAVeform<n>] is omitted, waveform 1
is adressed.
Parameters:
<State>
ON | OFF
*RST:
OFF
Usage:
Asynchronous command
CHANnel<m>[:WAVeform<n>]:TYPE
<DecimationMode>
Selects the method to reduce the data stream of the ADC to a stream of waveform
points with lower sample rate.
See also:
Suffix:
<m>
.
1..4
Selects the input channel.
<n>
1..3
Selects the waveform. If [:WAVeform<n>] is omitted, waveform 1
is adressed.
Parameters:
<DecimationMode>
SAMPle | PDETect | HRESolution | RMS
SAMPle
One of n samples in a sample interval of the ADC is recorded as
waveform point.
Acquisition and setup
