Instrument setup
R&S
®
RTO6
103
User Manual 1801.6687.02 ─ 05
4.7.3
Self-test
The instrument's self-test checks the hardware for correct operation. Perform the self-
test if you suspect problems in hardware operation.
Access: "Settings" >"Maintenance" > "Selftest"
The test can take several minutes. The summary result is shown in the "State" field,
which can be helpful in case you need support.
Selftest
Starts the self-test.
Remote command:
State
Shows the summary result of the self-test: Pass or Fail.
Remote command:
DIAGnostic:SERVice:STST:STATe?
Result
Opens a log file with detailed information on the self-test steps and operation of hard-
ware components, which can be helpful in case you need support.
4.7.4
Maintenance information
Access: "Settings" >"Maintenance" > "Hardware" tab > "Advanced"
The "Maintenance" dialog box provides information on your R&S
RTO6 configuration,
which can be helpful in case you need support.
System Info
This tab provides general information on the hardware configuration, and indicates
where system information can be found on the instrument. Here you can also show the
content of the device footprint file.
Maintenance settings
