Instrument tour
R&S
®
RTO6
31
Getting Started 1801.6670.02 ─ 03
Waveform generator option R&S RTO6-B6
The waveform generator generates various function and arbitrary waveforms,
sweeps, and parallel patterns. For detailed specifications, refer to the data sheet.
The option can be installed in the option slot at the rear panel.
The module provides the following connectors:
[Gen1, Gen2]
BNC connectors
[PattGen]
Connector for the pattern generator
Pulse source option R&S RTO6-B7
The pulse source outputs a symmetrical differential pulse signal. For detailed
specifications, refer to the data sheet.
The option can be installed in the option slot at the rear panel.
The module has four connectors.
●
Out,
: 2.92
mm connectors (K type) for pulse signal output
●
Ref,
: 2.92
mm connectors (K type) for reference signal output
GBIP option R&S RTO6--B10
The GBIP option provides a GBIP interface and connector for remote control. For
detailed specifications, refer to the data sheet.
5.3
Keys and controls
5.3.1
Power key
The [Power] key is located on the lower left corner of the front panel. It starts up
and shuts down the instrument's software.
The light of the key shows the instrument state, see
5.3.2
Trigger controls
The keys and knob in the Trigger functional block adjust the trigger and start or
stop acquisition.
Keys and controls
