R&S NRX Series, User Manual

Page: 385 / 514

Remote Control Commands
R&S
®
NRX
385 User Manual 1178.5566.02 ─ 07
MEMory:TABLe:DATA:POINts?
Queries the number of data pairs (frequency - offset) in the selected table.
Use
MEMory:TABLe:SELect
to select the table.
Usage: Query only
MEMory:TABLe:FREQuency <value>...
Defines the frequency values in the selected correction table. Existing data is overwrit-
ten. Take care that the number of frequency values matches the number of offset val-
ues, defined by
MEMory:TABLe:GAIN[:MAGNitude]
. If the numbers differ, excess
values are ignored.
Use
MEMory:TABLe:SELect
to select the table.
Setting parameters:
<value> Numeric values with a maximum of 2 digits after the decimal
point, separated by commas. Values with more than 2 decimal
places are rounded.
Default unit: Hz
Example: MEM:TABL:FREQ 50.00,60,70.3456
Sets 3 frequency values; 50.00 Hz, 60.00 Hz, 70.35 Hz.
Usage: Setting only
Manual operation: See "Edit table "<table name>"" on page 119
MEMory:TABLe:FREQuency:POINts?
Queries the number of frequency values in the selected correction table.
Use
MEMory:TABLe:SELect
to select the table.
Usage: Query only
Manual operation: See "Edit table "<table name>"" on page 119
MEMory:TABLe:GAIN:POINts?
Queries the number of offset values in the selected correction table.
Use
MEMory:TABLe:SELect
to select the table.
Usage: Query only
Manual operation: See "Edit table "<table name>"" on page 119
Managing Setups and Correction Tables
www.allice.de Allice Messtechnik GmbH