R&S NRX-B4, User Manual

Page: 26 / 450

Preparing for Use
R&S
®
NRX
26 User Manual 1178.5566.02 ─ 05
See Chapter 5.1.1, "Start Dialog" , on page 29.
If the previous session ended regularly, the R&S NRX uses the settings from the
last session.
3. If you want to return to a defined initial state, perform a preset.
See "Preset" on page 124.
To switch off the R&S NRX
1. Press the on/standby key.
The R&S NRX saves its current settings for reuse in the next session and changes
into the standby state.
2. To power down the R&S NRX completely, set the AC power switch to position [0]
(Off).
Further information:
●
Chapter 10, "Saving and Recalling Settings" , on page 123
●
Chapter 3.1.6, "On/Standby Key" , on page 18
4.8 Connecting Power Sensors
The R&S NRX supports a wide range of R&S power sensors. See the data sheet for
detailed information.
Depending on the power sensor, you have different choices for connecting it.
4.8.1 Sensor Connectors A to D
See Chapter 3.1.1, "Sensor Connector A and B" , on page 14 and Chapter 3.2.7, "Sen-
sor Connectors C and D" , on page 21.
Suitable for:
●
USB and LAN power sensors
●
R&S NRQ6
●
R&S NRP
‑
Zxx power sensors
NRQ6
Frequency Selective Power Sensor
LAN PoE+
Host
Interface
Sample Clock I/O (Default: 120 MHz)
LO I/0
Figure 4-1: Setup with an R&S power sensor (example)
Connecting Power Sensors